Water management for apartment buildings, paid for by the savings.
In a rental building the owner usually pays the water bill and the tenants control the taps. SMART reduces what the building uses and catches leaks early, through suite fixture retrofits, leak detection, submetering and irrigation management. Under our shared savings program the upgrades are installed at no upfront cost, and SMART is paid from a share of the savings we measure.
Where apartment buildings lose water.
The water bill is one of the few operating costs a rental owner can still bring down. This is where it goes.
Hundreds of the same fixtures
An apartment building repeats the same toilets, showers and faucets suite after suite. Older fixtures use more water than they need to, and the difference is multiplied by every suite in the building.
Leaks nobody reports
A running toilet or a dripping tap in a suite can go unreported for months, because the person who sees it does not pay for it. The waste shows up only on the owner's bill.
Systems nobody is watching
Risers, mechanical rooms, laundry rooms and garage-level equipment are looked after by a small site team with a long list. A failed fitting can run all night before anyone is back in the room.
Irrigation left on a timer
A controller on a fixed schedule waters in the rain, and a broken head or stuck valve runs every cycle until someone happens to notice.
What the program is not.
We do not bill tenants, and we do not promise a fixed dollar saving. SMART's payment is a share of the savings measured against the baseline in your agreement, so the program is built around water the building actually stops using.
What we install and look after.
Every building is different. The assessment shows which of these make sense. They are available through the shared savings program or as a standard service agreement.
- Suite fixture retrofits. High-efficiency toilets, showerheads and faucet aerators in the suites, replacing older fixtures that use more water than they need to.
- Leak detection. Leak sensors at the risk points and flow monitoring on the incoming service, with 24/7 automated alerts and shutoff where a valve is installed. See commercial leak detection.
- Submetering. Clamp-on ultrasonic sensors, or sensors on most existing meters, so use can be seen by riser, floor or system. See water submetering.
- Irrigation management. In Ontario, where the property has irrigated landscape: weather-based control with flow monitoring. Flow alarms on monitored sites are responded to within 48 hours, weekends included. See irrigation management.
- Irrigation maintenance. In Ontario, spring start-up, inspections, repairs and winterization by our own Certified Irrigation Technicians, with a written record after every visit. See commercial irrigation.
Everything reports into one client dashboard and one annual Water Intelligence Report, so the property has a single record of its water, indoors and out. See indoor water management and commercial irrigation.
Built for owners, asset managers and site staff.
No capital budget needed
Water upgrades often lose out to roofs, elevators and boilers in the capital plan. Shared savings moves them out of the capital budget: there is no upfront cost to the owner.
One record of the building's water
Monitoring, submetering and an annual Water Intelligence Report give the owner and the property manager a clear record of what the building uses and what changed.
The same view across every building
Each building reports through the same client dashboard and the same annual report, so buildings in a portfolio can be compared and the worst performers dealt with first.
Alerts to the people on site
24/7 automated alerts go to the contact chain you set, such as the superintendent and the property manager. SMART's Water Management team is staffed Monday to Friday, 7am to 11pm ET.
Questions we are asked.
What is a shared savings water program?
It is a way to upgrade a building's water fixtures and systems with no upfront cost. SMART pays for and installs the upgrades, then is paid a share of the water savings measured against an agreed baseline for a fixed term. The building keeps the rest of the savings.
Is there really no upfront cost?
Yes. Under the shared savings program the owner does not pay to install the agreed upgrades. SMART recovers its cost from its share of the measured savings over the term of the agreement.
How is the baseline set?
Before any work starts, we set the building's baseline water use from its water bills and meter records. The baseline, the savings share and the term are all written into the agreement.
Do you bill tenants?
No. SMART does not bill tenants. The agreement is with the building owner.
Do we have to use the shared savings program?
No. Leak detection, submetering and irrigation services are also available as a standard service agreement. The assessment shows which approach suits the building.
Which buildings qualify for shared savings?
Rental apartment buildings in Ontario, British Columbia and Alberta. The water assessment shows whether the savings in a particular building are large enough to support the program. Irrigation services are available in Ontario.
Find out what your building could save.
Tell us about the property. We will visit, look at the water systems indoors and outdoors, and send written findings.
Book a free assessment→Connect with us
Want to talk through one property or a portfolio? Call or email the team that looks after it.