Commercial irrigation repair, finished with a written report.
SMART repairs commercial irrigation systems across Ontario: mainline breaks, valve and wiring faults, damaged heads, controller faults and low pressure. Every service call ends with a written report of what was found, what was fixed and what still needs a decision, so the property manager can approve the next step with the facts in hand.
Our crews are in-house, every irrigation technician holds the Certified Irrigation Technician (CIT) certification, and we have been looking after commercial properties since 2007.
Commercial sprinkler repair: the failures we fix
Most commercial irrigation repair falls into five groups. The symptom you see is rarely where the fault is, so we diagnose the whole system first.
- Mainline breaks. The mainline stays pressurized whenever the system is on, so a split or a cracked fitting leaks around the clock, often under pavement or a planted bed. We isolate the section, locate the break, excavate and repair it, then restore the turf or hardscape we opened.
- Valve and wiring faults. A zone that will not open, a zone that will not close, or a valve that weeps between cycles. Worn diaphragms, debris, failed solenoids and wire cut during paving are the usual causes.
- Heads damaged by mowers and snow ploughs. Heads along curbs, walkways and parking islands take a beating every season: clipped by mowers, crushed by ploughs, pushed out of level by frost. We replace or raise them and reset arcs so water lands on the landscape, not the pavement.
- Controller faults. Lost programs, fault codes, failed stations, dead communication on a cellular controller, or settings changed by someone on site. We repair or reprogram the controller, and replace it when parts are no longer available.
- Low pressure and poor coverage. Dry patches that persist despite longer run times. We measure pressure and flow to find the cause: a leak upstream, a partly closed valve, too many heads on one zone or a supply problem.
On the sites we monitor, a stuck valve is as common as a broken pipe: in the 2026 season, about half of the confirmed mainline alarms with a recorded cause traced to a zone valve stuck open or weeping.
How a service call works, and what the written report shows
You report the fault
Call 888.444.1530 or send the details; on a managed site the flow alarm may report it first. A coordinator confirms the scope and books the visit.
Diagnosis, zone by zone
The technician runs each zone, checks pressure, walks the coverage and tests valves and wiring, so a fault two zones upstream is not mistaken for the one you saw.
Repair within the agreed scope
Routine repairs are completed on the visit. Anything beyond the agreed scope, such as a mainline excavation under pavement or a controller replacement, is quoted in writing before work begins.
The written report
What was found, what was repaired and with which parts, what was adjusted, and what remains, separated into items that need attention now and items that can wait for the budget cycle.
The report becomes part of the property's irrigation record. Properties on a commercial irrigation maintenance programme get the same report after every scheduled visit.
Repair or retrofit: when fixing it again stops making sense
Most faults are worth repairing. Heads, nozzles, solenoids and valve diaphragms are consumable parts, and replacing them is routine. The question changes when the same system keeps calling you back: the same lateral breaks every spring, wiring splices fail one after another, the controller is obsolete, or coverage was never right because the zones were laid out for a different site.
That is usually the point for a retrofit, not a full replacement. A controller upgrade with weather-based scheduling and flow sensing, high-efficiency nozzles and drip for beds and medians reuse the pipe that is still sound and remove the faults that keep recurring. The repair report is where that case gets made, because it shows how often the system has needed attention and why. See commercial irrigation installation and retrofit, and the commercial irrigation cost guide for how repair, retrofit and new installation are each priced.
Flow alarms on monitored sites: answered within 48 hours, weekends included
A repair visit fixes what someone noticed. Flow monitoring finds what nobody noticed: a valve stuck open overnight, a mainline leaking between visits, or a zone that stopped watering after a paving crew cut its wire.
On sites under irrigation management with flow monitoring, the controller compares measured flow with what each zone should draw. When something is wrong it sends a 24/7 automated alert, our water team reviews it, and irrigation flow alarms on monitored sites are responded to within 48 hours, including weekends. Where remote shutoff is installed, the affected zone or the mainline can be closed before a technician arrives. The alarm, the response and the repair all go into the same written record.
Who does the repair work
- Certified Irrigation Technicians on every crew. Every SMART irrigation technician holds the Certified Irrigation Technician (CIT) certification, and our irrigation designer is a Certified Irrigation Designer (CID).
- Landscape Ontario member. SMART is a full member of Landscape Ontario, and our CEO, Chris Le Conte, chairs its Irrigation Sector Group. Chris holds the Certified Landscape Irrigation Auditor (CLIA) and Certified Irrigation Contractor (CIC) certifications. SMART is also a member of the Irrigation Association.
- Experience at scale. 750+ commercial properties across Ontario and British Columbia, 200M+ litres of water saved per year, and 50+ years of combined leadership experience. Irrigation service is offered across Ontario.
Commercial irrigation is one of our two divisions. The other, indoor water management, watches the water inside the building, so one partner can see both sides of the meter.
Commercial irrigation repair, answered
Do you repair commercial irrigation systems another contractor installed?
Yes. Most of the commercial systems we service were installed by someone else. We record the system as we find it, repair it and, if you want, bring it under a maintenance or monitoring programme from there.
How quickly can you respond to an irrigation repair?
When you call, the coordinator books the visit and gives you the date. On sites with flow monitoring, irrigation flow alarms are responded to within 48 hours, including weekends, and where remote shutoff is installed the affected zone or mainline can be closed before a technician arrives.
How much does commercial irrigation repair cost?
Repair is priced per visit, with parts listed on the report. Anything beyond the agreed scope, such as excavating a mainline under pavement or replacing a controller, is quoted in writing before work begins. The commercial irrigation cost guide explains what drives the price.
What does the written repair report include?
What was found, what was repaired and with which parts, what was adjusted, and what still needs a decision, separated into items that need attention now and items that can wait for the budget cycle.
Should we repair or retrofit an older irrigation system?
Repair the consumable parts while the pipe and layout are sound. When the same faults keep returning, the controller is obsolete or coverage was never right, a retrofit with a new controller, flow sensing and high-efficiency nozzles usually costs less over time than repeated repairs.
Book a commercial irrigation repair
Call 888.444.1530 or send us the details: the property, the zone or area affected and what you are seeing. For a system that needs more than repairs, see installation and retrofit; for scheduled care, see commercial irrigation services.
Book a repair visit→Connect with us
Want to talk through one property or a portfolio? Call or email our service team.